eneo 2-wire transmission two-wire receiver 70568

This two-wire receiver, whose video input is equipped with an isolation transformer, can be used for both symmetrical video transmission via
twisted pair cables and asymmetrical video transmission via coaxial cables.
The receiver can compensate for signal losses that occur over long cables.
The outputs of the two-wire receiver distribute the asymmetrical video signal to four outputs.
The simple 12VDC power supply input simplifies battery operation.
The design of the system and the requirements for the environment guarantee long-term functionality.

Features
• Connection terminals and accessories enable mounting on mounting rails, Euro plug-in housings with 4TE, in switch cabinets (1 width unit)
or directly on a wall.
• Display and adjustment elements on the front side
• Connection via 15-pin Sub-D connector
• Polarity of the power supply is protected by a diode.
• ESD protection via a ferrite block
• Passive and galvanically isolated input
• Signal clamping for fixed black values
• Outputs for sync. and signal detection
• Distributed asymmetrical outputs

Technical data:
Symm. input 0.6-1.2Vss at 124Ohm
Asymm. input 0.7-1.3Vss at 75Ohm
Isolation video transformer 1kV
Error output Open collector output in series with 10Ohm, max. 80mA
Error deactivation Diode-collector, deactivated at 0.3V over GND
Sync. output 1Vss, 75Ohm termination, sync offset is GND
Amplifier 10MHz bandwidth, +30dB at 3 to 6MHz, adjustable to 1Vss
Asymm. output 1Vss, 75Ohm termination, black value clamping 1V
Power supply 11-17VDC, max. 150mA
Protection Ferrite block
Ambient temperature -25 to +55°C
Connection 15-pin Sub-D connector
Dimensions 90 x 50 x 17.5mm
Weight 100g
Housing Galvanized sheet metal connected to GND